NEC Express5800 series User Manual page 128

5. If the drive bay is covered by a metal EMI shield, insert your finger in the
large hole in one end of the shield (A) and pull the shield from the chassis.
Save the shield. See Figure 4-34.
6. Remove the new device from its protective wrapper and place it on an
antistatic surface. Record the drive model and serial number in the
equipment log.
7. Set any device jumpers or switches on the device. Refer to the installation
procedures that come with the device.
Note:
removed.
8. Device slide rails are included with your system. Attach two device slide
rails to the device (see Figure 4-35) and secure with four screws (two screws
per side).
4-46 Upgrading Your System
Figure 4-34. Removing the EMI Shield
All 5 1/4-inch devices must have terminators
Figure 4-35. Attaching the Device Side Rails
A
A