Using The Engine Start Feature - DieHard 200.713101 Owner's Manual

Your battery charger can be used to jump start your car if the battery is low. Follow
these instructions on how to use the ENGINE START feature.
1. Connect the chargerto the batteryand
vehicle as instructedin the "Charging
your battery"sectionon page 8.
2. Setthe right hand SELECTOR
SWITCHon ENGINESTART.
,
Crank the engine for no more than 5
seconds. If it does not start, wait at
least 4 minutes before cranking
again. In extreme cold or if the battery
is severely discharged, charge the
battery in the 10 amp position for about
5 minutes before cranking the engine.
4. After the engine starts, unplug the
charger power cord from the AC
outlet. Then disconnect the charger
from the battery.
IMPORTANT: Do not try to start the
engine without a battery in it. You could
cause damage to the electrical system.
If the engine does turn over, but never
starts up, there is no problem with
the starting system, but there is a
problem somewhere else in the vehicle.
STOP cranking the engine until the
other problem has been identified and
corrected.
10