Advertisement
CAUTION . . .
Make No Modifications
to this Sensor
Any modifications to this sensor not
expressly approved by Banner Engineering
could void the user's authority to operate
the sensor. Contact the Factory for more
information.
Specifications are subject to change without notice.
Range
Detectable Objects
Operating Principle
Operating Frequency
Supply Voltage
Supply Protection Circuitry
Delay at Power-up
Output Configuration
Output Protection
Indicators
Adjustments
Operating Temperature
Environmental Rating
Connections
Certifications
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Power LED
OFF
ON Green
Signal LED
TEACH Mode
(signal strength
indicator for
background)
RUN Mode
(alignment
indicator for
background
target taught)
Output LEDs
ON Red
ON Yellow
Specifications
Sensor will detect a 1 m x 1 m metal plate at a distance of up to 7.2 m (24') when set up with a suitable
background target.
Objects containing metal or other high-dielectric material
Frequency-modulated continuous-wave (FMCW) radar
24.05 to 24.25 GHz, ISM Band (varies slightly with national telecom regulations)
15 to 30V dc
Protected against reverse polarity and transient overvoltages
Less than 1.5 seconds
Bipolar NPN and PNP outputs, 150 mA (derate 1 mA per °C above 25° C)
Protected against short circuit conditions
Power LED: Green
Signal Strength LED: Red
Output LEDs: Yellow/Red
See "Status Indicators" above.
TEACH programming button for setting background reference
-20° to 55° C (-4° to 131° F)
IEC IP67; NEMA 6
2 m (6.5') or 9 m (30') 5-conductor, shielded, PVC-jacketed attached cable or integral 5-pin Euro-style QD
and ETSI/EN 300 440 or FCC Part 15, depending on model
R-GAGE™ QT50R Series Sensors
Status Indicators
Power is OFF.
Power is ON.
OFF
Background target is not sufficient; use a different
target.
ON Red (flashing)
Frequency of flash indicates alignment. LED flashes
faster as alignment improves; solid ON indicates
best alignment.
OFF
Background target is not being sensed.
ON Red (flashing)
Frequency of flash is proportional to background
target taught; solid ON indicates best alignment.
In TEACH mode.
In RUN mode; target is sensed and outputs are conducting.
Indicates
Indicates
Indicate
P/N 124617 rev. C
5
Advertisement
