Advertisement
Push Button
• Push and hold TEACH
push button until
Output LEDs turn
ON Red
• Press and release TEACH
push button
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
1. Mount the sensor securely. Align the sensor with the background target, making the
face of the Sensor as parallel as possible to the background target.
In programming mode (only after the TEACH push button is pressed), the red Signal
LED will flash faster as the alignment improves; solid ON is best. If the red Signal LED
does not flash, then the background target is not sufficient and a different target must
be used, such as a metal plate or a corner cube reflector.
2. Verify that the area between the sensor and the background is clear, and follow the
programming procedure in the table below.
General Notes on Programming
• Once the sensor enters TEACH mode, it will default to the previous settings and exit
TEACH mode after one minute.
• To exit TEACH mode and return to the previous settings, push and hold the TEACH
push button (or pulse the remote line) for more than two seconds.
Procedure
Remote Line
0.0 sec. < T < 0.8 sec.
• No action required; sensor is ready to be
aligned and programmed
• Pulse the remote line
R-GAGE™ QT50R Series Sensors
Sensor Programming
Power LED: OFF
Output LEDs: ON Red
Signal LED: Flashes faster as background
Power LED: ON
Output LEDs: OFF
Signal LED: ON solid
Power LED: OFF
Output LEDs: ON
Sensor defaults to program mode.
Result
signal strength increases (i.e.,
as alignment improves); solid
ON is best
Teach Accepted
Teach Unacceptable
P/N 124617 rev. C
3
Advertisement
