Table of Contents
Advertisement
CALLED
Washer doesn't Agitate.
Washer doesn't Spin.
MSEX0060i
CAUSE
Lid switch open.
Lid micro-switch wiring harness broken.
Pressure switch, wires broken.
Hose, pressure Switch damaged.
Motor or capacitor with problem.
Brake actuator burned.
Wiring Harness bad/broken.
Mechanism assembly locked.
ELECTRONIC CONTROL board with problems.
Too much soap powder.
Lid switch open.
Lid micro-switch wiring harness broken.
Wedge not tighten.
Brake actuator burned.
Wiring Harness bad/broken.
Pressure switch, wires broken.
Hose, pressure Switch damaged.
Water pump clogged or with problem.
Motor or capacitor with problem.
Mechanism assembly locked.
ELECTRONIC CONTROL board with problems.
SOLUTION
Replace Lid Switch.
Measure continuity between
involved wires. (R = 0).
Measure continuity between
involved wires. (R = 0).
Replace Hose, pressure Switch.
Check Motor doesn't run Topic on
this troubleshooting.
Replace actuator.
Connect/replace Wiring Harness.
Replace mechanism assembly.
Replace the Electronic board
(PCB).
Wait approximately 30 min and
repeat Double Rinse program.
Make a new evaluation on soap
powder quantity to be used
according to recommendation.
Replace Lid Switch.
Measure continuity between
involved wires. (R = 0).
Tighten the wedge.
Replace actuator.
Connect/replace Wiring Harness.
Measure continuity between
involved wires. (R = 0).
Replace Hose, pressure Switch.
Remove the object that is clogging
the Water Pump or replace it.
Check Motor doesn't run Topic on
this troubleshooting.
Replace mechanism assembly.
Replace the Electronic board
(PCB).
34
Advertisement
Table of Contents
