General Information; Glossary; Specification Chart - Sears 919.72512 Owner's Manual

GENERAL INFORMATION

You have purchased an air compressor unit consisting of a
one cylinder, single-stage air compressor pump and air
tank. Included are wheels, regulator, gauges, and handle.
This air compressor requires no oil. Now you can enjoy all
the benefits of having an air compressor without ever
having to purchase, add or change oil.
Your air compressor can be used for operating paint spray
guns, air tools, blow guns, nailers/staplers, air brushes,
CFM: Cubic Feet per Minute.
SCFM: Standard Cubic Feet per Minute; a unit of measure
of air delivery.
PSI: Pounds per Square Inch; a unit of measure of pres-
sure.
ASME: American Society of Mechanical Engineers; made,
tested, inspected and registered to meet the standards of
the ASME.
Cut-In Pressure: While the motor is off, air tank pressure
drops as you continue to use your accessory. When the tank
pressure drops to a certain low level and the pressure switch
lever is in "Auto", the motor will restart automatically. The
low pressure at which the motor automatically restarts is called
"cut-in pressure."
Model No.
Bore
Stroke
Voltage - Single Phase
Minimum Branch Circuit Requirement
Fuse Type
Amperage at Maximum Pressure
Air Tank/Capacity
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psi
SCFM @ 90 psi

GLOSSARY

SPECIFICATION CHART

and inflator kits. An air pressure regulator is required for
most of the applications.
An inline air filter which removes moisture and dirt from
compressed air should be used where applicable.
An inline regulator can be used if a more precise adjust-
ment of air pressure is needed downstream.
Cut-Out Pressure: When you turn on your air compressor
and it begins to run, air pressure in the air tank begins to
build. It builds to a certain high pressure before the motor
automatically shuts off - protecting your air tank from pres-
sure higher than its capacity. The high pressure at which the
motor shuts off is called "cut-out pressure."
CSA: Electrical products sold in Canada are required to be
certified to the applicable CSA standard (s). Canadian Stan-
dards Association (CSA) is a standards writing and safety
testing organization. Products that are CSA certified have
been evaluated and tested and found to meet or exceed the
applicable CSA standard (s) for safety and electrical perfor-
mance.
919.725120
15 amps
Time Delay
ASME/12 gal. (U.S.)
5
2 3/8"
1.35"
120
15.0
100
125
4.7
3.3