General Information; Glossary; Specification Chart - Sears 919.72633 Owner's Manual

GENERAL INFORMATION

You have purchased an air compressor unit consisting of a
one cylinder, single-stage air compressor pump and air
tank.
This air compressor requires no oil. Now you can enjoy all
the benefits of having an air compressor without ever
having to purchase, add or change oil.
Your air compressor can be used for operating paint spray
guns, air tools, blow guns, nailers/staplers, air brushes,
CFM: Cubic Feet per Minute.
SCFM: Standard Cubic Feet per Minute; a unit of mea-
sure of air delivery.
PSI: Pounds per Square Inch; a unit of measure of
pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Cut-In Pressure: While the motor is off, air tank pressure
drops as you continue to use your accessory. When the
tank pressure drops to a certain low level and the pressure
switch lever is in "Auto", the motor will restart automati-
cally. The low pressure at which the motor automatically
restarts is called "cut-in pressure."
Model No.
Number of Cylinders
Bore
Stroke
Voltage - Single Phase
Minimum Branch Circuit Requirement
Fuse Type
Amperage at Maximum Pressure
Air Tank/Capacity
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psi
SCFM @ 90 psi

GLOSSARY

SPECIFICATION CHART

and inflator kits. An air pressure regulator is required for
most of the applications.
An inline air filter which removes moisture and dirt from
compressed air should be used where applicable.
An inline regulator can be used if a more precise adjust-
ment of air pressure is needed downstream.
Cut-Out Pressure: When you turn on your air compres-
sor and it begins to run, air pressure in the air tank begins
to build. It builds to a certain high pressure before the
motor automatically shuts off - protecting your air tank from
pressure higher than its capacity. The high pressure at
which the motor shuts off is called "cut-out pressure."
CSA: Electrical products sold in Canada are required to
be certified to the applicable CSA standard (s). Canadian
Standards Association (CSA) is a standards writing and
safety testing organization. Products that are CSA certified
have been evaluated and tested and found to meet or
exceed the applicable CSA standard (s) for safety and
electrical performance.
919.726330
2 3/8"
15 amps
Time Delay
ASME/33 gal. (U.S.)
5
2
1.2"
240
15.0
100
125
15.0
11.5