Table of Contents
Advertisement
Medalist Pro Installation Guide, Rev. B
Terminator power
There are four possible terminator power ( TP ) configurations for
"W" model drives (see Figure 14). You will not normally need to
change this option and can leave the drive configured as it was
shipped from the factory.
"W" model drives
Drive supplies term. power for its own terminators only
Drive supplies term. power to SCSI bus only
Drive supplies term. power for its own terminators
and drive supplies term. power to SCSI bus
Drive takes term. power from SCSI bus
Note: TP jumper(s) must
always be in one of the
configurations shown,
even if TE jumper is
not installed.
Figure 14. Setting terminator power jumpers
J2 Jumper Type
(enlarged to
show detail)
J2
T
E
Position A
J6
Drive
Front
DC Power
Connector
W drives
Pin 1
R
D
M
W
P
E
T
T
S
E
P
D
S
P
P
(default)
J2
SCSI I/O
J1
Connector
49
Hide quick links:
Advertisement
Table of Contents
