Initial Setup Information - Seagate ST34573N/W/WD/LW/WC/LC Installation Manual

Barracuda 9LP Installation Guide, Rev. E

Initial setup information

The general information beginning on this page applies to all of
the Barracuda 9LP drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
Drive models
ST39173N
ST39173W/WD/LW
ST39173WC/LC
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
• Formatting the drive
1
This mounting procedure does not apply to "WC" or "LC" model
drives. To mount a "WC" or "LC" drive, plug the drive into the
system's single connector attachment (SCA) position on the
system's back panel.
ST34573N
ST34573W/WD/LW
ST34573WC/LC
Page
42
46
52
1
21