Table of Contents
Advertisement
2.7
Power specifications
The drive receives DC power (+5V and +12V) through a four-pin standard drive power connector.
2.7.1
Power consumption
Power requirements for the drives are listed in the table on page 7. Typical power measurements are based on
an average of drives tested, under nominal conditions, using +5.0V and +12.0V input voltage at 25°C ambient
temperature.
• Spinup power
Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.
• Seek mode
During seek mode, the read/write actuator arm moves toward a specific position on the disc surface and does
not execute a read or write operation. Servo electronics are active. Seek mode power represents the worst-
case power consumption, using only random seeks with read or write latency time. This mode is not typical
and is provided for worst-case information.
• Operating power and current
Operating power is measured using a standard
• Idle mode power
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in
a random track location.
• Standby mode
During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/
write electronics are in power-down mode.
Table 3:
DC power requirements
Power dissipation (watts)
Example: ST3400832ACE
Spinup
Idle
Operating (Consumer Storage Profile)
Seeking
Standby
Sleep
DB35 Series Product Manual, Rev. B
Consumer Storage Profile
Average
5V typ
(watts, 25° C)
amps
—
—
6.9
0.353
7.2
0.500
8.6
0.318
0.80
0.045
0.80
0.045
.
12V typ
amps
2.0 (peak)
0.519
0.400
0.585
0.013
0.013
7
Advertisement
Table of Contents
