Programming Worksheets - GE NX-320E Installation Manual

Programming worksheets

Use Table 10 to program Locations 1 to 7. Use the Data column to enter your programming information.
Table 10. Worksheet for Locations 0 to 7
Location Description
0
Location 0 - event and time for output A
1
Location 1 - special features for output A
Segment 1
1. On if timed in minutes; Off if timed in seconds.
2. On if latched until code is entered; Off for timed.
3. On if output should stop time when a code is entered (default).
4. On for inverted output.
5. On disables output during listen-in.
6-8. Reserved
Segment 2
1 = Partition 1
5 = Partition 5
2
Location 2 - event and time for output B
3
Location 3 - special features for output B
Segment 1
1. On if timed in minutes; Off if timed in seconds.
2. On if latched until code is entered; Off for timed.
3. On if output should stop time when a code is entered (default).
4. On for inverted output.
5. On disables output during listen-in.
6-8. Reserved
Segment 2
1 = Partition 1
5 = Partition 5
4
Location 4 - event and time for output C
5
Location 5 - special features for output C
Segment 1
1. On if timed in minutes; Off if timed in seconds.
2. On if latched until code is entered; Off for timed.
3. On if output should stop time when a code is entered (default).
4. On for inverted output.
5. On disables output during listen-in.
6-8. Reserved
Segment 2
1 = Partition 1
5 = Partition 5
6
Location 6 - event and time for the bell output
on page 11
on page 12
2 = Partition 2 3 = Partition 3
6 = Partition 6 7 = Partition 7
on page 12
on page 12
2 = Partition 2 3 = Partition 3
6 = Partition 6 7 = Partition 7
on page 12
on page 12
2 = Partition 2 3 = Partition 3
6 = Partition 6 7 = Partition 7
4 = Partition 4
8 = Partition 8
4 = Partition 4
8 = Partition 8
4 = Partition 4
8 = Partition 8
on page 12
Default Data
0, 10
3
1, 2, 3, 4,
5, 6, 7, 8
0, 10
3
1, 2, 3, 4,
5, 6, 7, 8
0, 10
4
1, 2, 3, 4,
5, 6, 7, 8
16, 0
15