Receiving Calls - Sony D-WAVE Zuma CM Z200 Operating Instructions Manual

Receiving calls

You can receive calls as long as the out-of-service icon
( ) is not displayed. The
are outside the service area.
When you receive a call, the ringer sounds or the phone vibrates. Incoming Call
flashes on the display, and the call alert indicator blinks.
1
If the arm microphone is closed, open it to answer the call. If the
arm microphone is open, press any button except
the call.
When the call is connected, the call timer appears and displays the elapsed
time.
2
Press or close the arm microphone to end the call when you are
END
finished.
The icon disappears, and the final elapsed call time flashes for 10 seconds.
The standby display automatically reappears.
Tips
• While the phone is ringing, turn
• Using the Jog Dial navigator, you can adjust the earpiece volume or mute the
microphone during a call (see pages XX and XX).
• If you turn off the ringer volume (see page XX), you will not hear the ringer sound. The
message -Ringer Off- is displayed on the standby display.
If the caller supports caller ID
The caller's phone number appears on the display when you receive a call if both
the caller and the carrier support this feature.
If the caller supports caller ID and the number matches a Phone Book entry, the
name that you stored with the number (if any) is displayed also.
If you miss a call
If you miss an incoming call, the message You have missed XX calls. appears on the
display. To return to the standby display, either press
supported caller ID, the caller's number is stored in the Calls List (see page XX).
3_CM_Z200
icon indicates that you
down to lower the ringer volume.
–
CLR
3
Arm mic
CLR
SEND
END
to answer
PWR
, , or . If the caller
END
3.3
6/8/98, 9:27 AM