Maintenance; Replacing The Fuse; Replacing Batteries In The 7300/7350 Remote Control; Fixing A Stuck Lid - Dometic FAN-TASTIC VENT Installation And Operation Manual

Fans and controllers
Hide thumbs Also See for FAN-TASTIC VENT:
Table of Contents

Advertisement

Fan

6 MAINTENANCE

6.1 Replacing the fuse

13
Fuse
Fuse Cap
➤ Locate the black cap on the face of the screen
assembly. Twist the cap in a counter-clockwise
direction (from right to left) 1/4 to 1/2 turn, and
gently pull down on the cap. The cap should come
free with the fuse attached to the backside.
➤ Inspect the fuse to see if the wire inside the glass
is broken and replace if necessary. Be sure to use
only a 4 amp "slo-blo" fuse.
➤ Place one end of the new fuse into the backside of
the fuse-holder cap and gently push the other end
of the fuse all the way up inside the fuse holder.
➤ Screw the black fuse cap back into place by
turning in a clockwise direction (left to right) until
snug (1/4 to 1/2 turn), and release.

6.3 Fixing a stuck lid

DAMAGE HAZARD: If the EPDM rubber dome seal is damaged or torn, contact Dometic for a
replacement.
➤ Open the dome (lid) all the way.
➤ Place a liberal amount of denatured or rubbing alcohol on a clean rag and clean the underside of the lid and
the EPDM rubber seal.
➤ If available, apply a water-based (not petrolium-based) protectant to the inside of the dome where the dome
and seal meet. Allow the protectant to dry and buff the lid with a soft cloth to a high sheen.
➤ Use a clean rag, paper towel or foam trim brush to apply an even coating of 100% silicone to the entire top
surface of the EPDM rubber dome seal to prevent it from sticking to the lid.
I
Wipe excess fluid off hands and wash thoroughly with soap and water.
EN
6.2 Replacing batteries in the 7300/
7350 Remote Control
14
Finger
Tab
➤ To remove the battery compartment cover located
on the rear of the remote, pull back on the finger
tab and lift.
➤ Match the (+) and (–) markings on the batteries
to the (+) and (–) markings inside the battery
compartment.
➤ To close the battery compartment cover, place
the alignment tab located opposite the finger tab
into the square hole on the back of the remote.
Push the cover down until the finger tab clicks into
place.
Square Hole
Alignment
Tab
Battery
Compartment
14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents