Table of Contents
Advertisement
FAN-TASTIC VENT
FAN
Fan-Tastic Vent™ Fans and Controllers
Fan-Tastic Vent
EN
Installation and Operation Manual
REVISION B | Form No. 8613-02 06/18 | ©2018 Dometic Corporation
Advertisement
Table of Contents
Related Manuals for Dometic FAN-TASTIC VENT
Summary of Contents for Dometic FAN-TASTIC VENT
- Page 1 FAN-TASTIC VENT Fan-Tastic Vent™ Fans and Controllers Fan-Tastic Vent Installation and Operation Manual REVISION B | Form No. 8613-02 06/18 | ©2018 Dometic Corporation...
- Page 2 NORTH AMERICAN ADDRESS INFORMATION USA & CANADA Service Center & Dealer Locations Service Office Visit: www.dometic.com Dometic Corporation 1120 North Main Street Elkhart, IN 46514 Read these instructions carefully. These instructions MUST stay with this product. CONTENTS Explanation of symbols and safety instructions ..........3 General information .
-
Page 3: General Information
(hereinafter referred to as “RV”) for which it ™ is supplied. The Fan-tastic Vent was designed to allow maximum airflow during the operation of vent fans while providing additional protection from the elements. -
Page 4: Fan Mounting
4 INSTALLATION FALL HAZARD: Vent fans are normally located on the roof of an RV. It is inherently dangerous to climb onto the roof of an RV to perform installation, maintenance, or repairs on a vent fan. Take appropriate precautions when climbing onto the roof of an RV or when working on the roof of an RV. - Page 5 RV and trims the ceiling cut-out. RV mfg. clamp fans require mounting screws and correct-height garnish, predetermined by a qualified installer and Fan-Tastic Vent. ➤ Clamp fans use a double-bead of compatible sealant between the fan base mounting flange and the roof (no putty tape, butyl or gaskets are to be used with clamp fans).
- Page 6 – Do not use this product in inclement weather. ➤ Close all outside vents when using your Fan-Tastic Vent. ➤ Slightly open the windows on the shaded side of the RV to provide the most comfortable ambient air, even on hot days.
- Page 7 5.3 Operating the reverse switch 5.4 Operating the thermostat ➤ With the lid open, select the desired temperature or comfort level on the thermostat. The fan motor will start and stop automatically as the interior temperature of the coach exceeds or drops below the selected temperature level.
- Page 8 Name Function Fan Power ON/OFF • Press to turn ON the fan (this will start the fan in Auto mode). • Press to turn OFF the fan (this will stop the fan and close the lid). Fan Speed • Press UP to increase the fan speed. •...
- Page 9 5.6 Model 5300, 5350 wall-mounted controls 5300 5350 When the fan is running: Closing the lid by pressing the UP/DOWN button shuts OFF the fan blade. Reopening the lid using the UP/DOWN button will revert the fan blade movement to its previous set speed.
- Page 10 5.7 Model 5200, 5250 RJ-11 wall-mounted controls 5200 5250 When the fan is running: Closing the lid by using the UP/DOWN button shuts OFF the fan blades. Reopening the lid by using the UP/DOWN button will revert the fan blade movement to its previous set speed.
- Page 11 5.8 Model 4200 RJ-11 wall-mounted controls When the fan is running: Closing the lid by using the UP/DOWN button shuts the fan blades OFF. Re- opening the lid using the UP/DOWN button will revert the fan speed to its previous set speed. Using the ON/OFF button will not do this;...
- Page 12 5.9 Model 4100, 4150, 4175 RAISE LOWER 4100 (Standard) ➤ Activate the fan by preselecting 1-LOW, 2-MEDIUM or 3-HIGH, on the fan-blade speed switch. ➤ On the wall control, press the RAISE/LOWER switch pad. Select the RAISE position and press it until the dome (lid) reaches the desired height, then release the switch pad.
- Page 13 5.10 Model 3300, 3350 ➤ Turn the three-speed knob to the desired speed (0-OFF, 1-LOW, 2-MEDIUM, or 3-HIGH). ➤ Select UP to raise the dome lid or DOWN to close the lid from the mini-rocker switch located near the lift motor.
-
Page 14: Replacing The Fuse
(left to right) until snug (1/4 to 1/2 turn), and release. 6.3 Fixing a stuck lid DAMAGE HAZARD: If the EPDM rubber dome seal is damaged or torn, contact Dometic for a replacement. ➤ Open the dome (lid) all the way. - Page 15 6.4 Cleaning the fan Fuse Fan Blade Pop N’ Lock ™ Screen Ring Fuse Cap ➤ Remove the fuse. Remove the Pop N’ Lock screen ring by grasping the finger tab with one hand and pulling ™ straight down. Use your free hand to brace against the screen assembly (control panel) to prevent breaking the Pop N’...
-
Page 16: Limited Warranty
LIMITED WARRANTY LIMITED WARRANTY AVAILABLE AT WWW.DOMETIC.COM/WARRANTY. IF YOU HAVE QUESTIONS OR TO OBTAIN A COPY OF THE LIMITED WARRANTY FREE OF CHARGE, CONTACT: DOMETIC CORPORATION CUSTOMER SUPPORT CENTER 1120 NORTH MAIN STREET ELKHART, INDIANA, USA 46514 +1-866-544-4881 OPT 4...