Installing The Power Modules And Input Power Cables - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing the Power Components

Installing the Power Modules and Input Power Cables

The power supply terminal posts are centered 0.63 inches (16 mm) apart and are 1/4-20 thread. We recommend
that you use an appropriately sized 90-degree angle, industry-standard, dual-hole, standard barrel compression
lug.
Figure 28: 90-Degree Angle Standard Barrel Compression Lug
Installing the Power Modules and Input Power Cables
This section describes how to install the power modules and AC and DC power cables in the Cisco NCS 6000
FCC. We recommend that you perform the installation in the order outlined in this section.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
45