Charger Location; Dc Connection Precautions; Battery In Vehicle Or Connection To Engine - Schumacher 00-99-000207 Instruction Manual

Wheel charger
Table of Contents

Advertisement

Available languages

Available languages

5.

CHARGER LOCATION

5.
Locate charger as far away from battery as charger cables permit.
5.2
Never place charger directly above battery being charged; gases from battery will corrode and
damage charger.
5.3
Never allow electrolyte to drip on charger when taking gravity readings or filling a battery.
5.4
Operate charger only in well ventilated area, free of dangerous vapors.
5.5
Store charger in safe, dry location and maintain in perfect condition.
5.6
Do not set battery on top of charger or where its acid might drip onto charger.
6.

DC CONNECTION PRECAUTIONS

6.
All switches should be set in OFF position and AC cord should be DISCONNECTED from
electrical outlet before you connect and disconnect charger clamps. Never allow clamps to
touch each other.
6.2
When attaching charger clamps, be certain to make the best possible mechanical as well
as electrical connection. This will tend to prevent clamps from slipping off connections, avoid
dangerous sparking, and assure safer and more efficient charging. Clamps should be kept clean.
CAUTION: SETTING SWITCHES TO OFF DOES NOT ALWAYS DISCONNECT CHARGER
ELECTRICAL CIRCUIT FROM AC POWER CORD OR DC CHARGER CLAMPS.
7.

BATTERY IN VEHICLE OR CONNECTION TO ENGINE

7.
Before working on vehicle, firmly apply emergency brake and place gear shift to NEUTRAL—shift
an automatic transmission to PARK.
7.2
Locate charger as far away from battery as charger cords permit and position AC and DC cords to
avoid stepping on or tripping over them and to prevent damage by hood, doors, or moving engine
parts.
7.3
Stay clear of fan blades, belts, pulleys, and any other parts that can cause physical injury.
7.4
Turn OFF all vehicle loads, including door lights, and correct any defects in car's electrical system
that may have caused low battery.
7.5
Check polarity of battery posts. POSITIVE (POS., P, +) post usually has larger diameter than
NEGATIVE (NEG., N,–) post.
7.6
Determine which post of battery is grounded (connected) to chassis. If negative post is grounded
(as in most vehicles), see paragraph 7.7. If positive post is grounded, see
paragraph 7.8.
▪ 9 ▪

Advertisement

Table of Contents
loading

Table of Contents