Table of Contents
Advertisement
R
4.11
MOvING MOWER WITH ENGINE
STOPPED
To "free-wheel" or move the mower around without the
engine running, turn the dump valve levers located on the
back of the pumps counter clockwise o the "freewheel"
position and move the mower by hand. To operate the
mower, the dump valves must be turned clockwise to the
closed position.
Dump Valve Levers
Figure 4-3.
4.12
RECOMMENDATIONS FOR MOWING
1.
Do not mow with dull blades. A dull blade will tear
grass, resulting in poor lawn appearance and
reduced mowing power.
WARNING
DO NOT operate without Discharge Chute,
Mulching Kit, or entire Grass Catcher properly
installed.
2.
The discharge chute must not be removed and
must be kept in the lowest position to deflect grass
clippings and thrown objects downward. Direct the
side discharge away from sidewalks or streets to
minimize cleanup of clippings. When mowing close
to obstacles, direct the discharge away from the
obstacles to reduce the chance of property damage
by thrown objects.
Dump Valves
3.
Cut grass when it is dry and not too tall. Do not cut
grass too short (cut off 1/3 or less of existing grass
for best appearance). Mow frequently.
4.
Keep mower and discharge chute clean.
5.
When mowing wet or tall grass, mow the grass twice.
Raise the mower to the highest setting for the first
pass and then make a second pass to the desired
height.
6.
Use a slow travel speed for trimming purposes.
7.
Operate the engine at full throttle for best cutting.
Mowing with a lower RPM causes the mower to tear
the grass. The engine is designed to be operated at
full speed.
8.
Use the alternate stripe pattern for best lawn
appearance. Vary the direction of the stripe each
time the grass is mowed to avoid wear patterns in
the grass.
14
Section 4
Hide quick links:
Advertisement
Table of Contents
