Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Saturn 2007 Relay Owner's Manual

Turn Signal On Chime
If either turn signal is left on for more than 3/4 mile
(1.2 km), a chime will sound to let the driver
know to turn it off. If you need to leave the signal
on for more than 3/4 mile (1.2 km), turn off the
signal and then turn it back on.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to
high beam, push the turn signal/multifunction lever
away from you.
To change the headlamps from high beam to low
beam, pull the turn signal/multifunction lever
toward you.
When the high beams
are on, this light will
appear on the
instrument panel cluster.

Flash-to-Pass

When the headlamps are off, pull the lever toward
you to momentarily turn on the high beams.
This will signal that you are going to pass. When
you release the lever, they will turn off.

Windshield Wipers

You control the windshield wipers by turning the
band with the wiper symbol on it.
(Mist): For a single wiping cycle, turn the
8
band to mist. Hold it there until the wipers start.
Then let go. The wipers will stop after one wipe.
If you want more wipes, hold the band on mist
longer.
(Off): To stop the wipers, move the band to off.
9
(Delay): You can set the wiper speed for a
N
long or short delay between wipes. This can
be very useful in light rain or snow. Turn the band
to choose the delay time. The closer to the top
of the lever, the shorter the delay.
185