Starting And Operating Your Vehicle; New Vehicle Break-In; Ignition Positions - Saturn 2007 Relay Owner's Manual

Starting and Operating
Your Vehicle

New Vehicle Break-In

Notice: Your vehicle does not need an
elaborate break-in. But it will perform better
in the long run if you follow these guidelines:
•
Do not drive at any one constant speed,
fast or slow, for the first 500 miles (805 km).
Do not make full-throttle starts. Avoid
downshifting to brake, or slow, the vehicle.
•
Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings are not yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every time
you get new brake linings.
•
Do not tow a trailer during break-in. See
Towing a Trailer on page 398 for the trailer
towing capabilities of your vehicle and more
information.
Following break-in, engine speed and load can
be gradually increased.
138

Ignition Positions

The key can be turned to one of four positions
while in the ignition switch.
A (LOCK): This is the only position from which
you can remove the key. This position locks
your ignition and transaxle.
Notice: Using a tool to force the key from the
ignition switch could cause damage or break
the key. Use the correct key and turn the key
only with your hand. Make sure the key is all the
way in. If none of this works, then your vehicle
needs service.