Attaching/Detaching The Lens - Panasonic Lumix H-ES200 Owner's Manual

• If you set the O.I.S. to [ON] when recording a motion
picture, operating sounds may be recorded. If they
become bothersome, we recommend setting the O.I.S.
switch to [OFF] and mounting the camera on a tripod.
∫
1.4k Teleconverter
2 3
1

Attaching/Detaching the Lens

For information on how to attach and remove the lens,
refer to the owner's manual for your digital camera.
• Before attaching or detaching the lens, check that the
digital camera is turned off.
• Before attaching the lens to the
digital camera, remove the lens
rear cap. ( 1 , 2 )
• To prevent dust and other particles
from accumulating on or entering the
lens, be sure to attach the lens cap/
lens rear cap after detaching the lens
from the digital camera.
6
DVQX1303 (ENG)
1 Fitting mark
2 Lens release
button
3 Lens fitting mark
4 Contact points
5 Lens mount rubber
4 5
∫
Attaching Filters
• If you use two or more filters at the same time, part of a
recorded image may darken.
• It is possible to attach the lens cap or the lens hood with
the filter already attached.
• It is not possible to attach a conversion lens or adaptor to
the lens surface and use it in combination with this lens.
Do not attach any items other than filters. Doing so may
result in lens damage.
∫
Attaching the Lens Hood
1
Rotate the lens hood screw
in the direction of the arrow
to loosen it ( 1 ).
2 Insert the lens hood until
it stops (2).
3 Rotate the lens hood
screw in the direction of
the arrow to fasten the
lens hood securely (3).
Note
• When using the lens with the lens hood, check if the lens
hood screw has become loose.
• When taking pictures with the flash with the lens hood
attached, the lower portion of the screen may turn dark
and the control of the flash may be disabled because the
photo flash may be obscured by the lens hood. We
recommend detaching the lens hood.