Contec FA-UNIT-F6BE/2U User Manual page 17

3. Installing the Motherboard
(3) Remove the backplane unit.
(4) Plug the expansion board and fasten it with a screw.
(5) Put the backplane unit back in place and connect the power cable to the ATX power connector on
the backplane. When the SBC in use is a CONTEC product, remove the short pin of CN1 and then
connect the SBC to the CN2 connector on the backplane using the attached power control cable.
(6) Put the shadow bay and cover back in place and fasten them with the screws.
12
FA-UNIT-F6BE/2U