Sanyo PLC-XW65K Owner's Manual page 61

Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
2
Loosen the screw with a screwdriver, slide and open
the lamp cover.
3 Loosen 3 screws of the lamp with a screwdriver and
pull out the lamp upwards vertically by grasping the
handles.
4
Replace the lamp with a new one and tighten the 3
screws back into position. Make sure that the lamp is
set properly. Replace the lamp cover and tighten the
screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp replacement counter .
See "Resetting the Lamp Counter" on the next page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
● Model No. of your projector
● Replacement Lamp Type No.
Lamp Cover
Screw
: PLC-XW65/PLC-XW65K
: POA-LMP129
(Service Parts No. 610 341 7493)
Maintenance and Cleaning
Screw
Screw
Handles
Lamp
Screw
61