Sanyo PLC-XU305K Owner's Manual page 55

Lamp control
Lamp control
This function allows you to change brightness of the
screen.
Normal ...... Normal brightness
Eco . ........... Lower brightness reduces the lamp
power consumption and extends the
lamp life.
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 .............. A lamp can be turned on even after
exceeding the recommended total
hours of use.
Mode  .............. A lamp can be turned on even after
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Note:
• Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize after
the power is turned on. Stored lamp mode will be active
after the lamp is stabilized.
• If Mode  has been selected and the projection lamp
exceedes the recommended total hours of use, the
replacement icon will be displayed at the time of power-
on. Then the projector will turn off after 3 minutes.
Lamp replacement icon
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.48), during "Freeze" (p.27),
or "No show" (p.28).
Remote control
The eight different remote control codes (Code 1–Code 8)
are assigned to the projector; the factory-set, initial code
(Code 1) and the other seven codes (Code 2 to Code 8).
The same code should set on both the projector and the
remote control. For example, operating the projector in
Code 7, the remote control code also must be switched to
Code 7.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control:
While holding down the MENU button, press the IMAGE
button the number of times corresponding to the remote
control code for the projector. See "Remote Control Code"
on page 13.
Note:
• When different codes are set on the projector and on the remote control, any operation cannot be made. In
that case, switch the code on the remote control to fit the code on the projector.
• If the batteries are removed from the remote control for a long period of time, the remote control code will
be reset.
Lamp life control
Remote control
Setting
55