Table of Contents
Advertisement
Auto setup
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP/
CANCEL button on the top control. Settings for those functions
can be altered as follows:
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point ▲▼
buttons to select one of the following options.
Off ......Input search will not work.
On1 ....Input search works under the following situation.
– When pressing the AUTO SETUP/CANCEL
button on the top control.
– When pressing the AUTO SET/CANCEL button
on the remote control.
On ....Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET/CANCEL button
on the remote control.
– When pressing the AUTO SETUP/CANCEL
button on the top control.
– When the current input signal is cut off.*
If the No show or Freeze function is active, cancel it to
*
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC Adj .
On . . . . . . Enables Auto PC Adjustment when pressing
the AUTO SET/CANCEL button on the
remote control or the AUTO SETUP/CANCEL
button on the top control.
Off . . . . . . Disables Auto PC Adjustment.
Auto Keystone
Auto . . . . Always works and corrects keystone
distortion according to the projector's tilt.
Manual . . Works only when pressing the AUTO SETUP/
CANCEL button on the top control.
Off . . . . . . Disables Auto Keystone.
Note:
•While Input search is set to On1 or On, the status of
Input and Lamp are displayed every time the signal is
switched.
•Only the last selected input source can be detected.
•If the INPUT button on the top control or COMPUTER,
VIDEO or NETWORK buttons on the remote control is
pressed during Input search is in progress, Input search
will stop and go back to the previous input signal.
• Auto PC Adj . and Auto Keystone cannot be set Off at the
same time.
Auto setup
Note:
• Auto Keystone corrects vertical distortion only, not
correct horizontal distortion.
• The Auto Keystone function cannot work when the
Ceiling feature is set On in the Setting menu (p.52).
• Perfect correction of the image distortion cannot
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP/CANCEL button, adjust manually
by pressing the KEYSTONE button on the remote
control or selecting Keystone in the Setting menu
(pp.25, 48).
• Fine sync ., Total dots, Horizontal and Vertical
position of some computers cannot be fully adjusted
with the Auto PC Adjustment function. When the
image is not provided properly with this operation,
manual adjustments are required (pp.33-34.
Setting
47
Advertisement
Table of Contents
