Replacing the M.2 solid-state drive
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove the monitor stand. See "Replacing the monitor stand" on page 20.
2. Remove the LCD panel. See "Removing the LCD panel" on page 22.
3. Depending on the computer model, refer to one of the following to replace the M.2 solid-state drive.
• Type 1
Figure 76. Peeling off the tape from the M.2 solid-state drive
Figure 77. Removing the screw
.
Chapter 4
Replacing hardware
43