Cable Routing - Yamaha YT175J 1982 Service Manual

CABLE ROUTING
~
...
Pass throttle cable and brake cable through
center of cable holder.
Breather pipe
Band position
Band: Secure lead only.
Route throttle cable over
handlebar and under
tension pipe.
Breather pipe: Pass under tension pipe.
Install both caps and put them together until they
contact each other.
Brake cable (hand): Route over fender stay and
side of seat rail.
Insert pipe into open end of main pipe.
Brake cable (hand)
Tension pipe
Air bleed pipe
Over flow pipe
Muffler
Clamp overflow pipe and air bleed pipe.
Brake cable (foot):
Pass under seat rail and
pass over the muffler.
Brake cable (hand):
Pass through under seat rail
and outside of air cleaner ea.;e.
Brake cable (hand) should pC'ss
over brake cable (foot).
~sE~~~9~t=S~~~~'.T··~·.~
Throttle wire and wire harness:
Route along left side of main pipe.
Band:
Breather pipe
Oil pipe
Clamp wire harness and lead.
Oil level gauge
Secure pipes
(4 pes.)/and
wire harness.
Wire harness and pipes (4 pes.)
Fender stay
Wire harness:
Bring it from outside of seat rail 'into braket.
Secure wire harness.
Clamp throttle 2 (2 pes.)
7-23
Lead