Carburetor; Flywheel Magneto - Yamaha YT175J 1982 Service Manual

3. Remove the air bleed pipes from
crankcase.
4. Remove the starter wire, air vent pipes,
overflow pipe, pulser pipe, and fuel pipe
from carburetor.
5. Disconnect the magneto lead wire.
Carburetor
1. Loosen clamps on each end of the car-
buretor.
2. Remove the carburetor.
Flywheel magneto
1. Remove the starter assembly.
2. Remove the starter pulley.
3-2
3. Remove the flywheel securing nut. (use
Flywheel holding tool)
1. Flywheel holding tool
4. Install flywheel puller on flywheel and
tighten it.
NOTE: _ _ _ _ _ _ _ _ _ _ _ _
The puller body has lefthand thread.
5. While holding puller body, tighten push
bolt. This will pull flywheel off the
tapered end of the crankshaft.
1. Aywheel puller