Clutch - Yamaha YT175J 1982 Service Manual

3. Install the shave drum in the starter case
and turn the shave drum 4 turns clock-
wise to give spring a preload. Then in-
sert the free rope end through the hole
respectively in the case and make a knot
of the rope end.
NOTE: ______________________ __
When installing the shave drum in the case,
make sure the inner end of the spring and the
split guide on the shave drum should be
hooked each other.
4. Install the drive pawl, drive plate spring,
and drive plate; then, tighten the spring
washer and nut.
Tightening torque:
10 Nm (1.0 m . kg, 7.2 ft-lb)
1. Drive plate spring
2. Drive pawl
NOTE: ___________________ _
Make sure the drive pawl, drive plate spring,
and drive plate are installed in the correct
way.
3-11
5. After the completion of assembly, check
the starter for smooth operation.
Pull out the starter rope about 80 - 130
mm (3 - 5 in), and make sure that the
starter pawl moves out of the drive
plate.
6. Install the starter assembly on the crank
case.
Tightening torque:
7 Nm (0.7 m' kg, 5.1 ft 'Ib)
Clutch
1. Measure the friction plates at three or
four points.
If
their minimum thickness
exceeds tolerance, replace.
New
Wear limit
Friction plate
2.4mm 2.1 mm
thickness
(0.09in) (0.08 in)