Removing Condenser; Removing Propeller Fan - Sanyo STB0810C1 Technical & Service Manual

9-7. Removing Condenser

(1) Remove the screws holding the condenser casing.
(Fig. 14)
(2) Remove the screws holding the condenser.
(Fig. 15)
(3) Hold the lower part of the condenser with both
hands and tilt slightly, then lift up carefully to avoid
distorting the copper tube.

9-8. Removing Propeller Fan

(1) Remove the condenser.
Refer to "9-7. Removing Condenser."
(2) Loosen the bolt holding the propeller fan on the
motor shaft. (Fig. 16)
(3) Remove the propeller fan from the motor shaft.
(Fig. 17)
Condenser casing
Condenser
Condenser
40
Fig. 14
Fig. 15
Fig. 16
Propeller fan
Fig. 17