Computer Mode; Selecting Input Source; Selecting Computer System - Sanyo PDP-31H1ENV Owner's Manual

COMPUTER MODE

REMOTE CONTROL OPERATION
Select "PC" or "RGB 1" by pressing PC/RGB button on Remote
Control Unit.
FRONT CONTROL OPERATION
Select "PC" or "RGB 1" by pressing INPUT button on Front Control.
NOTE :
"RGB 2" is used for RGB Video signals from 21-PIN connector. (Refer
to "CONNECTING TO VIDEO EQUIPMENT" on page 13.)
This Plasma Monitor automatically tunes to most different types of computers based on VGA, SVGA or XGA (refer to
"COMPATIBLE COMPUTER SPECIFICATIONS" on page 31). When selecting Computer, this Plasma Monitor automatically
tunes to incoming signal and display proper image without any special setting. (Some computers need setting manually.)
If the Monitor cannot be tuned, follow in message will be displayed.
Out of scan range
No signal
28

SELECTING INPUT SOURCE

SELECTING COMPUTER SYSTEM

When Plasma Monitor cannot recognize
connected signal that PC system provides in the
message "Out of scan range" is displayed on
screen.
There is no signal input from computer. Make
sure the connection of computer and Plasma
Monitor is set correctly.
PC
RGB 1
RGB 2