Troubleshooting; Operational Problems - Sony RM-SC200 Operating Instructions Manual

Switching the volume control
function
Normally the VOL+ and – buttons function
for adjusting the receiver's sound volume.
You can switch the functions of the VOL+
and – buttons for adjusting the TV's sound
volume.
UNIT OFF TV OFF SYSTEM OFF
TV VCR1 VCR2 DBS/CATV
TUNER CD MD TAPE
MUTING VOL JUMP/ CH
SHIFT
1 Make sure that the slide cover is closed.
2 Press the TV button.
3 Press the TV, VOL+, and VOL– buttons
simultaneously.
To switch back to the receiver's sound
volume, repeat the same procedure as
above.
Precautions
•Do not open the cabinet. Refer servicing to
qualified personnel only.
•Do not leave the unit in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust, moisture, rain or
mechanical shock.
•Do not use alcohol, benzine, or thinner to
clean the cabinet.
Slide cover
If you have any questions or problems
concerning your unit that are not covered in
TV
this manual, please consult your nearest
Sony dealer.
+ -
VOL /

Troubleshooting

If you hook up or set up any of your
components incorrectly, you may have
problems using your entertainment system,
including powering on/off components, or
making components respond incorrectly to
the commander. Try the following
suggestions to solve these problems.

Operational problems

If you have problems operating any of your
components, check the following:
•If you press a button on the commander
and the component does not respond,
point the commander directly at the TV
and press the button again. If the
component still doesn't respond, point the
commander at the receiver and press the
button again.
Continued
17
RM-SC200.3-858-330-11.E