Engine Oil And Filter - HUSTLER Z Diesel Operator's Manual

Shown in right fuel tank position
B
A. Fuel shutoff valve
B. Fuel shutoff position
Figure 4-5
A
A. Priming bulb
Figure 4-6
Engine Controller (Tier 4 Engines Only)
The engine controller is used on all Tier 4 engines. It
monitors and controls the engine's fuel emissions. When a
problem is detected, a code is sent to the Engine Warning
Light located on the control panel.
REV J
A
C
D
C. Left fuel tank
D. Right fuel tank
Refer to the Hustler
115164) for code identification and troubleshooting.
A
A. Controller

Engine Oil and Filter

If the engine has been running and is up to
operating temperature, allow the engine to cool
before changing the oil. Engine and engine oil will
be very hot, so be very careful when changing oil
and wear the appropriate protective gear to avoid
being burned or exposed to engine oil.
Check engine oil daily and after every 4 hours of operation.
Machine must be setting level when checking oil. Refer to
engine manual and
recommendation and capacities. Hustler
recommended.
Change the engine oil and filter after the first 5 hours of
operation and
recommendations after that. If mower is being operated in
extremely dirty conditions, then it is recommended oil be
changed more frequently.
oil filter take precautions to minimize oil spillage on the
exhaust system.
The oil filter and oil drain plug are located on the
underneath side of the engine. Figure 4-8
4-4
Z Diesel General Service Manual (P/N
®
Figure 4-7
maintenance schedule
®
per the engine manufacturer's
When removing the
IMPORTANT:
for oil
Motor Oil is
603695