Sanyo KHS2432 Instruction Manual page 7

REMOTE CONTROL
Operation selector
OFF position
TEST position
OPERATION lamp
STANDBY lamp
OI-212-07EG
Unit Display and Operation Selector (continued)
OPERATION lamp
STANDBY lamp
TIMER lamp
This section picks up infrared signals from the remote control unit
receiver (transmitter).
ON position This position is for operating the air conditioner with the wireless
remote control unit.
The selector should normally be set in this position.
Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
This position is used only when servicing the air conditioner.
Do not set at the TEST position for normal operation.
CAUTION
This lamp lights when the system is in the continuous AUTO,
HEAT, COOL or FAN mode.
This lamp lights when the system is warming up for heating and
when the system is defrosting. To keep a constant room
temperature, the air conditioner continues to supply a gentle
breeze when warming up or when the heating operation is
paused by the thermostat.
TIMER lamp This lamp lights when the system is being controlled by the timer.
INDOOR UNIT
REMOTE CONTROL receiver
STANDBY
Operation selector
7