Operation With The Remote Control Unit; Automatic Operation - Sanyo KHS2432 Instruction Manual

1. Automatic Operation

NOTE
NOTE
OI-212-13EG
Operation with the Remote
Control Unit
STEP 1
Check that the circuit breaker on the power panel is turned on and that the
operation selector of the indoor unit is in the ON position.
When Automatic operation mode
steps below, the air conditioner operates automatically and brings the room
to the desired temperature simply by pressing the ON/OFF operation
button.
STEP 1 Press the MODE selector to
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation button again.
To change the temperature setting, press the temperature setting
•
buttons and change the setting to the desired temperature.
The indicates the upper limit for the temperature setting and the
indicates the lower limit.
The temperature setting changes by two degrees each time one of the
•
TEMP . buttons is pressed.
Although the fan speed is set automatically, you can change the fan
•
speed by pressing the FAN SPEED selector button as shown below.
STEP 2
is selected and the unit is set using the
.
13