Table of Contents
Advertisement
❸ Turning on the Projector
NOTE:
• The projector has two power switches: A main power switch and a POWER button (POWER ON and OFF on the remote control)
• Turning on the projector:
1. Press the main power switch to the ON position (I).
The projector will go into standby mode.
2. Press the POWER button .
The projector will become ready to use.
• Turning off the projector:
1. Press the POWER button.
The confirmation message will be displayed.
2. Press the POWER button again.
The projector will go into standby mode.
3. Press the main power switch to the OFF position (O).
The projector will be turned off.
1. Remove the lens cap from the lens unit.
2. Press the main power switch to the ON position ( I ).
POWER indicator lights up in green. If there is no opera-
tion from the unit or communication from the connected
device, the unit will go into the standby state after a while.
(When the standby mode is set to "Normal")
(→ page 126)
2. Projecting an Image (Basic Operation)
16
Advertisement
Table of Contents
