Natural Gas Conversion - Kenmore W11123999C Installation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

4. Apply masking tape to the end of a
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice
spud and remove by turning the Natural gas broil burner
orifice hood counterclockwise to remove. The hood will be
stamped with a "155."
5. Replace the "155" hood with a "100" hood. Install
the Propane gas broiler burner orifice hood, turning it
clockwise until snug.
IMPORTANT: Do not overtighten.
A. Orifice hood
6. Place the broil burner on the broil burner orifice hood.
Insert the broil burner ceramic igniter in the hole in the
rear of the oven.
7. Replace the flame spreader with all 4 tabs facing up
and the notches toward the rear of the oven.
8. Position the broil burner against the top of the oven
and attach it with 1 screw.
9. Replace storage drawer. See the "Remove/Replace
Drawer" section.
10.
Replace the oven door. See the "Oven Door" section.
11.
Replace the oven racks.
Complete Installation (Natural Gas to Propane Gas)
1. Refer to the "Make Gas Connection" section for proper
connection of the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition and operation.
3. Refer to the "Adjust Flame Height" section for burner
flame adjustments.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop flame is very important. The
small inner cone should have a very distinct blue flame
1
/
" to
1
/
" (0.64 to 1.3 cm) long. The outer cone is not
4
2
as distinct as the inner cone. Propane gas flames have a
slightly yellow tip.
4. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.
/
" (1 cm) nut driver
3
8
A

Natural Gas Conversion

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Turn the manual shut-off valve to the closed position.
A
A. Gas supply line
B. Manual shut-off valve closed position
C. To range
2. Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Propane Gas
to Natural Gas)
1. Remove the storage drawer. See the "Remove/Replace
Drawer" section.
2. Locate gas pressure regulator at rear of the drawer
compartment.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
B
C
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents