System Setting - CAMDEN CM-550SK-V2 Installation Instructions Manual

CM-550SK-V2 WATERPROOF KEYPAD
INSTA L L AT I O N I NST RU CTI ONS

7.3 System Setting

Standby Master Code
Red Flash Red
* Master Code #
7.4 User Optional Setting
Standby Master Code
Red Flash Red
* Master Code #
Notes:
1. Master code must be 6-8 digits.
2. Anti-duress PIN must be 8 digits.
3. User PIN is 4-6 digits.
4. The user ID number is any number from 1-2000
5. Door open time is 0-99 second, 0=50mS.
6. While operating the keypad, pressing # means to confirm the input digits, in operation of a cycle adding or deleting PIN
code, pressing # means to end the cycle operation and back up the operation; pressing * means to exit the operation.
7. Keypad Wiegand modes are set at the factory to 26 bit. If the output format is changed through programming, the
changes are not affected by a reset to factory defaults.
Page 4 of 11
Menu Setting
Red Orange
30 0-15 #
0 #
31
1 #
33 0-2 #
34 1-3 #
0 #
35 1 #
2 #
Menu Setting Remarks
Red Orange
0 #
41
1 # Default 1
0 #
42
1 #
0 #
43
1 # Default 1
Remarks
Default 0
This setting is not
affected by resetting
to factory default.
This setting is not
affected by resetting
to factory default.
Default 1
Default 0
Functions
Buzzer is turned off, except while in programming mode
Buzzer will sound during key presses
Disable keypad backlighting
Enable keypad backlighting
LED Light Disable while in stand-by
LED flashes while in stand-by
Functions
To Set Facility Code
Wiegand Reader
Standalone for Single Door
To set keypad
transmission format
0=26 bit weigand
1=4 bit burst
2=8 bit burst
To set alarm time in minutes
Normal mode
Lock out mode
Alarm mode