Scotsman DXN 207 Service Manual page 16

Page 15
MENU PROGRAM
Through the menu program it is possible the
setting of the machine operating parameters,
and view/clear some counters.
To enter in MENU program, press the ALARM
button, even if it is OFF for 10''. Entering in the
programming mode the display will turn ON all
LEDs except ALARM and DELAY. Use the UP
Menu Program Description
Dispensing Water
Touch or Touchless version
Dispensing time
Machine model
Menu Program Description
Compressor working hours
PC Board working hours
Dispensing drive motor working
hours
Cleaning Remind
Firmware version
*
There is a third option choosing "ØØØ" the bin empty function will be disabled
Display Counter Reading Mode
Compressor, PC Board and Dispensing Drive
Motor current working hours can be read on
display through its three digits and dots.
As per following meaning:
• Digits are working hours
• Dots are decimals to add
I.e.
999 = 999 working hours
999. = 9990 working hours
99.9. = 99900 working hours
OPERATING STATUS
Using the capacitive keys on display is possible
to know at what stage the machine is operating,
except during an active warning alarm.
To do it, push the Red Alarm Key for 5 seconds
and DOWN capacitive keys to navigate through
the menu and choice of parameter values, ICE
key is used to select and confirm the selection,
WATER key to cancel or ESC.
Pushing the ICE key the selected value will flash
and will be saved as the current value for the
parameter and return to the list main parameters.
Push WATER key for more than 5 seconds to
return to operating mode.
Display Option 1
H On: water dispensed
F Tch : Touch
S 1 up to 15 seconds
-d- 100 = DXN 100
Display Meaning and reset mode
C Shows the current working hours of compressor
Push ICE key to reset the counter
P Shows the current working hours of main PC Board
Push ICE key to reset the counter
I Shows the current working hours of dispensing drive motor
Push ICE key to reset the counter
C L E Push ICE key to reset the counter before the cleaning time is elapsed
-U- Shows the current version of the firmware installed on the main PC
Board of the machine
when it is OFF, the display will show the code of
the current status of the machine:
Status
Firmware version
Start-up Delay (purge time)
Start-up Delay ( fill up time)
Water Error (when no water is detected)
Ice level control beam interrupted
Bin Full
Ice level control beam resumed
Start-up
Start-up checks
Making ice
Ice level control auto calibration
Water reservoir drain
The Display automatically will switch off after 5
seconds.
CLEANING REMIND
The need to clean the machine is signaled by the
LED ALARM and "CLE" on display after 6 months
of operation. When this remind appear, the
machine and the panel nevertheless continue to
Option 2 Default Setting
Off: water disabled On
TcL : Touchless tch
CON= continuos 3 sec.
200 = DXN 200 100
Display Code
Page 15
*
Pxx
d01
dØ2
FØ6
FØ5
bF1
bF2
FØ3
F01
F04
F02
Pur