Connecting The Water Supply Hose; Drain Hose Connection Procedures; Positioning The Drain Hose - Samsung WM1255A Owner's Instructions Manual

Installing the Washing Machine

Connecting the water supply hose

1. Remove the adaptor from the
water supply hose.
2. First, using a '+' type screw driver,
loosen the four screws on the
adaptor. Next, take the adaptor
and turn part(b) following the
arrow until there is a 5mm gap.
3. Connect adaptor to the water tap
by tightening the screws firmly.
Then, turn part (b) following the
arrow and put(a) and (b) together.
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use
the most conventional type of faucet for water supply. In case the faucet is square or too
big, remove the spacing ring before inserting the faucet into the adaptor.
Note:
The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be used.

Drain hose connection procedures

1. Holding down the handle of the drain hose
connector, put in the drain hose in desired
direction.
: Fix the hose into the drainage hole, and give
the hose connector a push to the body to fix
the hose.

Positioning the drain hose

The end of the drain hose may be positioned in three
ways:
Over the edge of a wash basin.
The drain hose must be placed at a height of
between 0 and 90 cm. To keep the drain hose spout
bent, use the supplied plastic hose guide. Secure
the guide to the wall with a hook or to the faucet
with a piece of string to prevent the drain hose from
moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no longer than 90
cm.
4. Connect the water supply hose to
c
5. Connect the other end of the water
•
a
b
SAMSUNG Washing Machine Owner's Instructions 5
the adaptor. Pull down part (c) of
the water supply hose.
When you release part (c) the
hose automatically connects to the
adaptor making a 'click' sound.
supply hose to the inlet water
valve at the top of the washer.
Screw the hose clockwise all the
way in.
If the water tap has a screw type
faucet, connect the water supply
hose to the tap as shown.