Chapter 5 Link Operating State View; Viewing Link State In Default Mode - Samsung Version 2.1 User Manual

OfficeServ Link Version 2.1 User Guide
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
Successful disconnection changes the connection state of Link and indicates it
as
from【

Chapter 5 Link Operating State View

When the communications environment setup, telephone system linkage, user management,
and device management have been completed for the Link and the Link is running normally,
each user can access to the Link as needed.
This chapter describes the operation state for Link in normal service.

Viewing Link state in Default mode

Figure 5.7 shows the normal working of Link running in default mode. While the Link is
running in this mode, the user connection state window shows the following information:
IP address
Indicates the IP address of connected user computer.
Port No.
Indicates the port No. used for TCP/IP communication with the Link. The port No. of
Link corresponds to that set in the communication environment. Default is 6000.
Page 36
, and changes the [Disconnect] button
】to 【 】.
Figure 5.1 Link running in default mode
Message Monitoring
© SAMSUNG Electronics Co., Ltd