Table of Contents
Advertisement
Connecting to a network
Unit or accessories
necessary for connecting
The following devices and accessories are
necessary in order to use this unit as a
development machine:
• Development Tool
• Network cable
• Hub
• Development PC
Connection diagrams
Before connecting a cable, rotate the aerial in a
clockwise direction, and raise it upright. If the
cable is connected first, it may not be possible to
rotate the aerial.
Connecting to a network without a
DHCP server
You can build a local network with this unit and
a development PC in the following manner.
Preparing to use
The unit
Controller
At this time, the following static IP addresses are
automatically set for the unit:
• IP address : 192.168.0.10
• Subnet mask : 255.255.255.0
Caution
• The IP address and subnet mask settings are default factory
settings. When the network settings for the unit are
modified, these settings are also modified accordingly.
• To modify the IP address, start up both the unit and the
development PC, and configure their respective settings to
support the network to which they are to be connected.
After configuration, use a network cable to connect the unit
and the development PC to a hub within the network in use.
Refer to "Setting up" on page 17 for infomation on how to
set up the unit.
2
Chapter
the unit
Hub
Development PC
15
Connecting to a network
Advertisement
Table of Contents
