Samsung ITP-5107SIP User Manual page 19

• Select the [3. NETMASK SET UP] menu
and press SPEAKER, the LCD will display
the following message and the user can
enter a new Netmask IP address. Use the
HOLD button to backspace.
Check if there is any currently saved subnet mask address of the phone on the
LCD. If the subnet mask address has not been set, the display will show nothing.
Press any dial buttons from [0]-[9] and [,] button to enter the subnet mask IP
address and then save that subnet mask IP address by pressing the SPEAKER but-
ton. Use the HOLD button to backspace.
• Select [4. GATEWAY SET UP] menu and
press SPEAKER, the LCD will display the
following message and the user can
enter a new gateway address.
Check if there is any currently saved Gateway IP address of the phone on the LCD.
If the gateway IP address has not been set, the LCD displays nothing.The user can
enter the gateway IP address by using [0]-[9] and [,] button and can save that IP
address by pressing the SPEAKER button. Use the HOLD button to backspace.
NOTE: In the [3. NETWORK SET UP MENU], [1. NETWORK MODE SETUP] option,
when [2. DHCP] is selected the IP address, Netmask, and Gateway will not be dis-
played on the LCD. Press HOLD to exit to Main Menu.
Load and Upgrade Set/Modify
The fourth item [4. LOAD & UPGRADE SET UP] sets or modifies the IP phone's
software version. Use extreme caution when upgrading the keyset. Only use this
if you are upgrading your IP keyset firmware.
Select the [4. LOAD & UPGRADE SET UP] item and move to the lower level. The
screen below is displayed.
1.UPGRADE TFTP SERVER
2.UPGRADE START
Select option [1. UPGRADE TFTP SERVER] and enter the IP address of the TFTP
server containing the ITP software. Use [0]-[9] and [,] button to enter the IP
address. Press SPEAKER to save.
Select option [2. UPGRADE START] and press SPEAKER to start the upgrade
process. Press HOLD to exit.
12
INPUT NETMASK & PRESS OK
xxx.xxx.xxx.xxx
INPUT GATEWAY & PRESS OK
xxx.xxx.xxx.xxx