7-4
Non-Display Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
3. Remove the antenna.
4. Pry off the volume and channel selector knobs from their shafts using the knob removal/chassis
opener tool (Motorola part # 6686533Z01).
Note: Both knobs slide on and off. However the knobs are designed to fit very tightly on the shaft.
5. Separate the chassis from the front housing assembly by using the knob remover/chassis opener
too. Place the broad side of the opener into the slots located at the base of the radio
Press the handle on the opener downwards. This pressing action forces the thin inner plastic wall
toward the base of the radio, releasing the two chassis base tabs..
CAUTION: Marring the front cover O-ring sealing area will prevent the radio from sealing properly. If the
!
O-ring is damaged, replace it with a new one.
Note: The speaker wire assembly microphone wire assembly and keypad ribbon connector con-
December 3, 2003
More user manuals on
Figure 7-2. Antenna and Knob Removal
Radio Chassis
Figure 7-3. Chassis Removal
necting the front housing assembly and the chassis prevent the two units from being com-
pletely separated
ManualsBase.com
(Figure
7-2)
Knob Remover/
Chassis Opener
(Figure
7-3).
HKLN4215A