Configuring The Encs 5400-W Device; Adding Or Removing Raid-1 For Encs 5400-W Series; Migrating Equipment From No Raid And 1 Ssd To Raid-1 And 2 Ssds - Cisco ENCS 5406-W Quick Start Manual

Encs 5400-w series
Table of Contents

Advertisement

Configuring the ENCS 5400-W Device

Configuring the ENCS 5400-W Device
This section contains the following topics:
Before You Begin

Adding or Removing RAID-1 for ENCS 5400-W Series

Note
The RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and later.
Note
Do not swap or replace a drive used by another ENCS system without reformatting it beforehand.
This section contains the following topics:
For further information on RAID and the ENCS 5400 Series, see the
Note
Compute System Hardware Installation

Migrating Equipment from No RAID and 1 SSD to RAID-1 and 2 SSDs

This section contains two topics:
Before You Begin
The RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and later.
Note
Cisco ENCS 5400-W Series Quick Start Guide
12
Adding or Removing RAID-1 for ENCS 5400-W Series
CLI Commands Used with ENCS 5400-W
Verify that the specified ENCS 5400 Series chassis (ENCS 5406-W, 5408-W, or 5412-W) is already
installed and powered up. For information on how to install the an ENCS 5400 Series device, see
the
Cisco 5400 Enterprise Network Compute System Hardware Installation
If you need to add or remove RAID-1 for your system, see
5400-W
Series. Note that the RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and
later.
Migrating Equipment from No RAID and 1 SSD to RAID-1 and 2 SSDs
Migrating Equipment from RAID-1 and 2 SSDs to No RAID and 1 SSD
Before You Begin
Procedure for Creating the Virtual Disk
Verify that the supported RAID card has been inserted into the ENCS device.
Verify that each slot has an SSD inserted; the SSD is used to perform RAID-1 configuration.
Before creating the virtual disk, both drives must be in Unconfigured Good state. If drive is in other
status, use the CIMC Web GUI or CLI and do the following:
Adding or Removing RAID-1 for ENCS
Guide.
Guide.
Cisco 5400 Enterprise Network

Advertisement

Table of Contents
loading

This manual is also suitable for:

Encs 5408-wEncs 5412-w

Table of Contents