Makita EB7660TH Instruction Manual page 4

The engine is to be switched off immediately if there are any
6.
engine problems.
7. When working with the blower, always wrap your fingers
tightly around the handle, keeping the control handle cra-
dled between your thumb and forefinger. Keep your hand
in this position to have your machine under control at all
times. Make sure your control handle is in good condition
and free of moisture, pitch, oil or grease.
8. Always ensure a safe, well-balanced footing.
9. Carry the blower properly on both shoulders during opera-
tion. Do not carry the blower with only one shoulder strap.
Otherwise personal injury may result.
10. Operate the blower in such a manner as to avoid inhalation
of the exhaust gases. Never run the engine in enclosed
rooms (risk of suffocation and gas poisoning). Carbon mon-
oxide is an odorless gas. Always ensure there is adequate
ventilation.
11. Switch off the engine when resting or leaving the blower
unattended. Place it in a safe location prevent danger to
others, setting fire to combustible materials, or damage to
the machine.
12. Never lay the hot blower onto dry grass or onto any com-
bustible materials.
13. All protective parts and guards supplied with the machine
must be used during operation.
14. Never operate the engine with a faulty exhaust muffler.
Transport
1. Shut off the engine during transport.
2. Position the blower safely during car or truck transportation
to avoid fuel leakage.
When transporting the blower, ensure that the fuel tank is
3.
completely empty.
Lift the blower with holding carry handle when you carry it.
4.
Do not drag the blower by nozzle, pipe or other parts.
5. Hold the blower firmly during transportation.
6. When transport the blower, bend your knee and make sure
you do not damage your shoulder and lower back.
Refuelling
1. Shut off the engine during refuelling, keep well away from
open flame and do not smoke.
2. Avoid skin contact with petroleum products. Do not inhale
fuel vapor. Always wear protective gloves during refuelling.
Change and clean protective clothing at regular intervals.
3. Take care not to spill either fuel or oil in order to prevent soil
contamination (environmental protection). Clean the blower
immediately after fuel has been spilt. Allow wet cloths to dry
before disposing in properly, covered container to prevent
spontaneous combustion.
4. Avoid any fuel contact with your clothing. Change your
clothing immediately if fuel has been spilled on it (fire
hazard).
5. Inspect the fuel cap at regular intervals making sure that it
stays securely fastened.
6. Carefully tighten the locking screw of the fuel tank. Change
locations to start the engine (at least 3 meters (10 ft) away
from the place of refuelling).
7. Never refuel in closed rooms. Fuel vapors accumulate at
ground level (risk of explosions).
8. Only transport and store fuel in approved containers. Make
sure stored fuel is not accessible to children.
9. Do not attempt to refuel a hot or a running engine.
10. Do not refuel more than the amount defined in
"SPECIFICATIONS".
Method of operation
1. Use the blower only in good light and visibility. Beware of
slippery or wet areas, ice and snow (risk of slipping), and
narrow space. Always ensure a safe footing.
2. Never work on unstable surfaces or steep terrain.
3. Do not work from ladders or high places. Otherwise it may
result in personal injury.
4. To reduce the risk of personal injury, do not direct air blast
towards bystanders, since the high pressure of the air flow
could injure eyes and could blow small objects at great
speed.
5. Never insert any foreign object into the air intake of the
machine or into the nozzle of the blower. It will damage the
fan wheel and may cause serious injury to the operator or
bystanders as a result of the object or broken parts being
thrown out at high speed.
6. Pay attention to the direction of the wind, i.e., do not work
against the wind.
7. To reduce the risk of stumbling and loss of control, do not
walk backward while operating the machine.
8. Always shut off the engine before cleaning or servicing the
unit or replacing parts.
9. Take a rest to prevent loss of control caused by fatigue. We
recommend to taking a 10 to 20-minute rest every hour.
10. Keep all parts of your body away from hot surfaces.
11. Avoid blowing debris towards people, pets, open windows,
or cars when using unit.
12. To reduce damage from vibration and/or damage to the ears,
operate the machine at low speed if possible and limit the
time of operation.
13. Operate the machine only at reasonable hours. Do not oper-
ate the blower in the morning or late at night when people
might be disturbed.
Comply with times listed in local ordinances.
14. It is recommended for using rakes and brooms to loosen
debris before blowing.
15. Before blowing, slightly dampen surfaces in dusty condi-
tions or use water mist sprayer if necessary.
16. Conserve water by using blowers instead of hoses for many
lawn and garden applications, including areas such as gut-
ters, screens, patios, grills, porches, and gardens.
17. Adjust the length of the blower nozzle so that the stream
can work close to the ground.
4 ENGLISH