Table of Contents
Advertisement
OPERATING THE RECEIVER
4.7 Copy Channel Data
If you want to copy the channel data from one receiver
to another, please follow the instruction below.
Please make your own channel data, such as favorite
& lock channel with your own master box.
Then take your master box when you install another box.
1. Plug on both master & slave receivers
2. Master Box(Installed Box) : Stand-by Mode
3. Slave Box(Installing Box) : Menu Mode
4. Connect 2 Boxes with RS232 serial cable
(Both end should have male connector with crossed signals)
5. Select the 'System Setup' and press the OK key.
6. Select the 'Copy Channel Data' with the
7. Press 'OK' to start channel data copy
/
keys.
34
D
I
G
I
T
A
L
S
Problem
No display LED on
the front panel;
No power supply
No pictures on the screen
No sound
Remote Control does not
operate directly
Poor picture quality
signal strength in
On-Screen Error Message
"Searching for signal"
On-Screen Error Message
"Channel data
does not exist."
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with
household refuse. Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate locations provided.
A
T
E
L
L
I
T
E
R
E
C
E
TROUBLESHOOTING
Possible cause
Solution of the problem
Power cord
Power cord plug in correctly
not plugged in correctly
Receiver in Standby mode;
Set receiver to "On";
RCA not connected tightly
Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television
correct (TV instruction manual)
Audio cord connected
Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active
Press the MUTE key
incorrect operation;
Point remote control
towards the Receiver.
Batteries dead or inserted
Replace batteries or insert correctly
incorrectly
Signal strength to low
Check all wire connections. Check the
the "Auto Scanning" menu, correct
alignment of your antenna
Antenna cable not connected
Check connection and correct;
or not tight;
LNB defective;
Change LNB;
incorrect position of the
Check position and correct,
satellite antenna;
Check the signal strength in
LNB is set to "OFF" in
the "Auto Scanning" menu
LNB Setting menu
Satellite not yet set
Scan of in "Auto scanning"
or "Manual scanning" menu
35
I
V
E
R
Advertisement
Table of Contents
