Samsung RS26WUNS Owner's Manual And Installation page 33

INSTALLATION OF THE WATER DISPENSER LINE
Secure the purifier in position.
- Fix the purifier in position, as shown in the figure
on the right.
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
Secure the water line.
- Using clip "A", fix the water line to the wall (the back of
refrigerator).
- When the water line is secure, make sure whether the water
line is not excessively bent, pinched or squashed.
Remove any residual matter inside the water supply line after installing filter
1) Turn on the main water supply & shut-off valve of the water
supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
NOTE
WATER TUBE
PURIFIER
TIGHTENING
BAND
WATER LINE
33
PURIFIER
LOCK STATIONS
CONNECTION NUT
COMPRESSOR COVER OF
REFRIGERATOR
CLIP A
WATER LINE
ICE
WATER