Playing Clips; Playing Recorded Clips; Playing The Selected And Subsequent Clips In Sequence; Adding Shot Marks During Playback (Exfat, Udf) - Sony PXW-Z280T Operating Instructions Manual

Playing Clips

Playing recorded clips

You can play recorded clips when the camcorder
is in recording standby (Stby) mode.
1
Insert an SxS memory card for
playback.
2
Press the PLAY/PAUSE button of the
playback control buttons.
3
Search for the desired clip by pressing
the PREV or NEXT button.
4
Press the PLAY/PAUSE button.
The playback image appears on the
viewfinder.
You can control playback by pressing the
following buttons.
PLAY/PAUSE button: Pauses playback. To
resume playback, press this button again.
F FWD button/F REV button: Plays fast. To
return to normal playback, press the PLAY/
PAUSE button.
STOP button: Stops playback or recording.
To select the first thumbnail
Press and hold the F REV button and press the
PREV button.
To select the last thumbnail
Press and hold the F FWD button and press the
NEXT button.
Playing the selected and
subsequent clips in sequence
1
Press the V/v/B/b button or turn the
SEL/SET dial to move the cursor to the
thumbnail for the clip you want to play.
2
Press the SET button or SEL/SET dial.
Playback begins from the start of the selected
clip.
Notes
• There may be momentary picture breakup or still
image display at the boundary between clips. You
cannot operate the camcorder during this period.
• When you select a clip in the thumbnail screen and
begin playback, there may be momentary picture
breakup at the start of the clip. To start playback
without distortion, pause playback once after starting
it, press the PREV button of the playback control
buttons to return to the top of the clip, then restart
playback.
Adding shot marks during
playback (exFAT, UDF)
You can add shot marks to clips during playback
by pressing buttons the same way as used during
recording.
In a region where you want to insert shot
marks, press the assignable buttons
assigned with Shot Mark1 or Shot Mark2.
Notes
• Shot marks cannot be recorded when the SxS memory
card is write protected.
• Shot marks cannot be recorded at the start or end of a
clip.

Monitoring audio during playback

In normal playback mode, you can monitor the
recorded audio signals through the built-in
speaker or connected headphones.
Connecting a set of headphones to the headphone
jack (page 10) cuts off the built-in speaker.
Adjust the volume using the VOLUME buttons
(page 11).
You can select the channel to monitor using
Audio Output (page 102) in the Audio menu.
73