Samsung DA99-01225E Owner's Manual And Installation page 36

INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply & shut-off the valve of the
water supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the fridge door and check if water leaks around the
water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
NOTE
Check the amount of water supplied to the ice tray.
1) To remove : Set the type of ice to the "Ice Off" position. Lift up
(①) and pull out (➁) the ice bucket in the freezer.
To replace : When replacing the drawer, be sure to press it firm-
ly into place. If it does not go all the way back, remove it and
rotate the drive mechanism 1/4 turn. Then push the drawer back
again.
2) Throw away the first few batches of ice to allow the water line to
clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will
stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink.
• Place the ice tray at the originally provided posistion by manufacturer in order to achieve optimal
NOTE
ice-freezing.
ICE
ICE BUCKET
ICE MAKER
Feeler Arm
36
WATER
Rotate
Drive
Mechanism