Clearing Indicator Problems - Samsung SP-H800 Owner's Instructions Manual

Indicator Information
: Turned on : Blinks
TEMP LAMP STANDBY

Clearing Indicator Problems

Classification State
Measure 1 When the cooling fan system is
not in normal operating condition.
Measure 2
When the lamp cover protecting
the lamp unit is not properly
closed or the sensor system is not
in normal operating condition.
When temperature inside of the
Measure 3
projector becomes too high.
Measure 4 The lamp is malfunctioning after
abnormal power off or restarting
right after turning off the projector.
When brightness of the picture
screen degrades or image
deterioration is found.
: Turned off
If you press the POWER button on the remote control or projector, the screen
appears within 30 seconds.
The projector is in normal operating condition.
This state appears when the projector is preparing an operation after the POWER
button on the projector or the remote control has been pressed.
The POWER button is pressed to turn off the projector, and the cooling system is
in operation to cool off inside of the projector. (Lasts for about 1 minute and 30
seconds)
Refer to measure 1 below if the cooling fan inside the projector is not in normal
operation condition.
Refer to measure 2 below if the lamp cover protecting the lamp unit is not closed
properly.
Power is turned off automatically when temperature inside of the projector goes
beyond the control limit. Refer to measure 3.
Refer to measure 4 below if the life span of the lamp is running out or a problem
with the lamp is detected.
If the symptom remains even after disconnecting and then
reconnecting the power cord and turning the projector on
again, contact your product provider or our service center.
Check the screw on the bottom side of the projector. If you
do not find any problem, contact a dealer or service
personnel near you.
Adjust the position of the projector following the
installation instructions of this manual and cool off the
projector before restarting it. If the problem does not
disappear, contact a dealer or service personnel near you.
Turn the power off, wait for a sufficient amount of cooling
time and then turn the power on for operations.
Check how long the lamp has been used on Information
and contact a dealer or service personnel near you for lamp
replacement.
NOTE
Information
Measures
This Projector uses a cooling fan system to keep
the unit from overheating.
Operation of the cooling fan may cause noise,
which does not affect the product performance.
No exchange or refund for the noise concern.
9